The valve seat is responsible for the movement of the valve gate. It can also help to further seal the flowing medium. For gate valves, there are two valve seats according to the type of gate. Take the wedge valve as an example, the valve seats on both si

Gate valves and globe valves are the two most common types of valves in industrial applications. Both have made great contributions to any industrial service. They may look similar, but the functions of these valves are different.

The main difference between these two types is the way they are closed. The stop valve uses a plug (stem) that closes against the flow, while the ball valve has a gate (ball) that can close the entire flow. The stop valve is suitable for adjusting the flo

The valve is made of stainless steel and the material is 304/316. They can be used to control the flow of water, oil and gas, including various corrosive and radioactive media.

The structure of the wafer butterfly valve is formed by the central disc rotating 90 degrees in the valve body. Using the drive type, the flow of fluid can be stopped, adjusted or started. In the wafer connection, the valve is installed between pipe flang

Ball valves are often used for steam, water, oil, gas, air, and corrosive fluids. They can handle slurries and dusty dry fluids. The ball valve is not used for abrasive and fibrous materials, because it will damage the surface of the valve seat and valve

The gate valve is the most common valve in the water supply system. It represents a linear motion isolation valve with the function of stopping or allowing flow. The gate valve is named after the closing element slides into the flow stream to provide clos

Good sealing performance improves the reliability of the system. The friction resistance is small, the opening and closing is forceful and flexible. It has a long service life and can be switched repeatedly. High pressure and high temperature resistance,

The gate valve can provide different discs or wedges. The range of the gate valve is usually determined by the type of wedge used.

Ball valve is a form of right-angle rotary valve, which uses a hollow, perforated and rotating ball to control it. It is open when the hole of the ball is aligned with the hole of the ball, and it is closed when it is rotated 90 degrees by the valve handl

Gate valves can be divided into two main types: parallel and wedge. The parallel gate valve uses a flat gate between two parallel valve seats. The popular type is a knife gate valve with sharp edges on the bottom of the gate.

For non-vertical stem type valves, if the valve is opened, the stem will not move upward. The stem is screwed into the dish. When the handwheel on the valve stem rotates, the disc moves up or down along the valve stem on the thread, while the valve stem r

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

A three-way ball valve is a three-way valve that allows fluid to flow to an alternative path to the hydraulic system. It allows fluid to enter and exit the valve through more than one port.

In the shut-off valve, the flow of water is controlled by a movable mandrel, and the flow of water is restricted by lowering the mandrel to a fixed valve seat.