The valve cage is a part of the valve, which surrounds the valve plug and is located in the valve body. The valve cage is the main component that determines the fluid flow in the valve. As the stopper moves, more cage openings are exposed and the flow rat

The assembly, start-up, and maintenance of gate valves require a lot of space.

The gate valve is composed of three main parts: the valve body, the valve cover and the valve trim. The body is generally connected with other equipment through flange, thread or welding connection. The engine cover containing the moving parts is usually

Ball valves are valued for their long service life and excellent performance even after many years of use. Inside the ball valve, the ball is usually drilled from one end to the other, and is usually made of brass, chrome brass, or stainless steel. A leve

If the flow, volume and pressure can be adjusted frequently, the stop valve can be used as a control valve. The design of the shut-off valve makes it very suitable for flow regulation and start and stop flow.

The stop valve opens and closes the valve with the help of a plug-shaped disc, which is tightly fixed in the valve.

These shut-off valves have one or more ports, and their valve bodies are spherical around the port area.

Ball valves and plug valves are very similar in basic functions and applications. Both are control valves used to provide tight shutoff in different types of piping units. They also work on the same basic principle, that is, using a porous disk to start o

There are many types of gate valves, such as full bore gate valves, parallel disc gate valves, solid wedge gate valves, flexible wedge gate valves, split wedge gate valves, vertical stem gate valves, and non-vertical stem gate valves.

Gate valves Gate valves are called rising valves or non-rising valves. Around the non-vertical stem gate valve, the stem is screwed into the gate around the lower end surface. Because the handwheel around the valve stem rotates, the gate will move the val

Because of its ability to cut off liquids, gate valves are often used in the petroleum industry. For extremely viscous fluids, special valves commonly called knife valves are used to cut off the liquid. A typical gate valve is designed to be fully open or

The valve cover provides a leak-proof closure to the body. The threaded valve stem part will pass through a hole that has a thread similar to the valve cover, and the valve stem with the threaded part extends into the same hole as the valve cover thread.

You can expect the service life of the shut-off valve to be approximately 10 to 25 years, with an average of 20 years. However, if they are not "exercise" once a year or two years, then when you really need to close the valve for a pipeline emer

The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.

Ball valves are more effective in forming tight seals and have higher reliability and life than gate valves, but they are more expensive. They are often used to shut down and control applications. Because the ball valve can be opened and closed instantane