The closing function of gate valves is very good. They provide laminar flow with minimal pressure loss.

The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g

The valve cage is a part of the valve, which surrounds the valve plug and is located in the valve body. The valve cage is the main component that determines the fluid flow in the valve. As the stopper moves, more cage openings are exposed and the flow rat

Good sealing performance improves the reliability of the system. The friction resistance is small, the opening and closing is forceful and flexible. It has a long service life and can be switched repeatedly. High pressure and high temperature resistance,

Wafer type is a common style of butterfly valve, which is cheaper than lug type. The wafer butterfly valve is installed between two flanges. The valve is held in place from flange to flange by using bolts or studs and nuts. Of course, this type of install

When the handle wheel is turned clockwise, steam and steam move down through the fluid flow, and the gate is squeezed between the two valve seats, so that no fluid leakage occurs when the valve is completely closed.

Gate valves are widely used in all types of applications, suitable for above-ground and underground installations. Especially for underground installations, it is important to choose the correct type of valve to avoid high replacement costs.

You can expect the service life of the shut-off valve to be approximately 10 to 25 years, with an average of 20 years. However, if they are not "exercise" once a year or two years, then when you really need to close the valve for a pipeline emer

The gate valve is a valve that completely restricts the flow of fluid and provides a full-diameter valve without changing the direction. The valve disc is appropriately called a gate here and is moved into the fluid at right angles by a threaded shaft wor

These shut-off valves must not be used for on/off service because it is impossible to achieve a tight seal. The disc in the valve can be completely removed from the flow path, or the flow path can be completely closed.

In the 19th century, due to the increasing use of gate valves in industrial operations, their intensive development moved forward rapidly. Over time, the materials involved in manufacturing have been improved and modified to suit different applications.

Electric actuator ball valves have full-diameter models, some are cavity-filled, and some are V-shaped ball valves. Designed for throttling or switching applications in a variety of industries, including pulp and paper, chemical, power, oil and gas, and m

The gate valve is the most common valve in the water supply system. It represents a linear motion isolation valve with the function of stopping or allowing flow. The gate valve is named after the closing element slides into the flow stream to provide clos

The sealing ring adopts seatback type, mortise type or directly vulcanized on the valve body. The sealing surface of the valve seat flange adopts an O-ring to cooperate with the pipe flange cone, and the sealing effect is good. It is easy to disassemble a

Compared with ball valves, gate valves require multiple turns to fully open. The valve is not suitable for throttling or control, because partial opening will cause damage to the gate and wear of the valve seat. In addition, some valve closures can cause